Contec BUF-PCI(PC) User Manual page 31

Restarting the system
Restart your system.
Running the BUF-PCI self-diagnostic program
Run the BUF-PCI self-diagnostic program following these steps.
(1) From the Windows NT Start button, select Programs.
(2) Select BUF-PCI self-test (VC) in CONTEC BUF-PCI.
(3) The self-diagnostic program runs and displays self-testing results
and resources assigned from the PC to the BUS-PCI(PCI).
Notes!
- The IRQ Level item is not displayed if you disable the use of
interrupt resources with DIP switch SW1 on the BUS-PCI(PCI)
board.
- DOSST.EXE as the self-diagnostic program for DOS cannot run
under the Command prompt.
- If self-testing results are not OK, see troubleshooting described later
in this manual.
Checking Resources
Follow the steps below to check the assigned resources managed by the
OS.
(1) Open [Windows NT Diagnostic Program] from [Management
Tools].
(2) Select [Resources] (IRQ/port settings). Check the types and
settings of resources assigned to the relevant driver and the
corresponding device list.
BUF-PCI(PC), BUF-PCI(98)
Setup
23