Contec BUF-PCI(PC) User Manual page 25

Running the BUF-PCI self-diagnostic program
Run the BUF-PCI self-diagnostic program following these steps.
(1) From the Windows XP Start button, select Programs.
(2) Select BUF-PCI self-test (VC) in CONTEC BUF-PCI.
(3) The self-diagnostic program runs and displays self-testing results
and resources assigned from the PC to the BUS-PCI(PCI).
Notes!
- The IRQ Level item is not displayed if you disable the use of
interrupt resources with DIP switch SW1 on the BUS-PCI(PCI)
board.
- DOSST.EXE as the self-diagnostic program for DOS cannot run
under the Command prompt.
- If self-testing results are not OK, see troubleshooting described later
in this manual.
Checking Resources
Follow the steps below to check the assigned resources managed by the
OS.
(1) Open [Control Panel] from [My Computer].
(2) Double-click on the [System] to open the [System Properties]
property sheet.
(3) Select [Hardware] tab and select [Device Manager...] to open the
Device Manager.
(4) Click on the [Multifunction adapters] folder.
(5) Click on the [CONTEC Co.,Ltd.-BUS-PCI(PCI)] folder to display
its properties.
(6) Select the [Resources] tab to check the resource settings and the
conflicting device list.
BUF-PCI(PC), BUF-PCI(98)
Setup
17