Table of Contents
Advertisement
Method of Installing Two or More BUS-PCI(PCI) Boards :
Follow the procedure below to install two BUS-PCI(PCI) boards for
use under Windows 98.
(1) Check that the first BUS-PCI(PCI) board has been set up correctly,
as described in "Checking resources". Be sure to complete
installation of the first board before attempting to install the
second one.
(2) Exit Windows 98 and turn the personal computer off.
(3) Check the board ID of the second BUS-PCI(PCI) board, then plug
it into a PCI bus slot. Assign ID to the second board a board ID
that is different from the ID assigned to the first board.
(4) Turn the personal computer on again to start up Windows 98.
(5) Windows 98 will come up with the [New Hardware] detection
dialog box. In the [Add New Hardware Wizard] that appears next,
check that "CONTEC Co., Ltd.-BUS-PCI(PCI)" has been listed,
then select [Next>].
(6) In the next dialog box, select a radio button of [Display a list of all
the drivers in a specific location, so you can select the driver you
want.], then select [Next>].
(7) In the next dialog box, select "CONTEC Co., Ltd.-
BUS-PCI(PCI)" from [Models], then select [Next>].
(8) In the [Windows driver file search for the device] dialog box,
check that "CONTEC Co., Ltd.-BUF-PCI(PCI)" and
"CONTEC~*.INF" in the [Location of driver] has been listed, then
select [Next>]. (* is a number which the OS assigned.)
(9) In the next dialog box, check the "Windows has finished installing
the software that your new hardware device requires." message,
then select [Finish]. This completes installation of the BUS-
PCI(PCI) board. After finishing installing the board, confirm the
assigned resources again.
BUF-PCI(PC), BUF-PCI(98)
Setup
29
Advertisement
Table of Contents
