Cutting Angle; Dust Extraction; Mounting The Splinterguard; Operation - Festool TS 75 EQ Instruction Manual

7.1
7.2
7.3

Cutting angle

The sawing unit can be swivelled between 0° and
45°:
8.1
8.2
- Loosen rotary knobs (8.1, 8.3),
- Swivel sawing unit to the desired cutting angle
(8.2),
- Retighten rotary knobs.
Note: both end positions (0° and 45°) are set at the
factory and can be readjusted by the after-sales
service team.

Dust extraction

Particularly for work in closed areas, we recom-
mend that you connect your circular saw to a chip
extractor. This will enable you to reduce the dust
load in the air, ensuring that your workplace is clean
and improving the quality of your work.
9.1
A Festool dust extractor with an extractor hose di-
ameter of 36 mm or 27 mm (36 mm recommended
due to the reduced risk of clogging) can be connect-
ed to the rotating extractor connector (9.1)

Mounting the splinterguard

10.1
10.2
The splinterguard (accessories) signifi cantly im-
proves the quality of the cutting edge of the sawn
workpiece on the upper side for 0° cuts.
8.3
- Attach splinterguard (10.1) onto the protective
cover,
- Place machine onto the workpiece or the guide
rail,
- Press splinterguard down until it sits on the work-
piece and tighten it with the rotary knob (10.2).
- Saw splinterguard in (machine to maximum cut-
ting depth and speed range 1).
Use the splinterguard only for 0° cuts. Always re-
move the splinterguard for mitre cuts. When mak-
ing mitre cuts, the splinterguard raises the portable
circular saw from the workpiece, which can lead to
serious injuries.
structions before starting work!

Switching the machine on and off

switching and during use by holding the handle
(11.2) and the additional handle (11.1) with both
hands.
To switch on, fi rst push the cut-in and release block
(11.4) forwards, and then press the „On"-"Off"
switch (11.3). You can then press the machines down
for sawing, and release the cut-in and release block.
9

Operation

Read and understand the safety in-
Keep the machine steady during