Maintenance - Makita DCL282F Instruction Manual

Cordless cleaner
Hide thumbs Also See for DCL282F:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Disposing of dust
CAUTION:
Empty the cleaner before it
becomes too full, or the suction force weakens.
CAUTION:
When closing the front cover, be
careful not to pinch your fingers.
NOTICE:
Never throw away the dust stopper
because it should be used whenever either the
dust bag or the paper filter is used.
NOTICE:
When the dust bag/paper filter is not
inside of the cleaner, the front cover does not
close completely. Do not force to close the front
cover. It may result in deforming or breakage of
the tool.
NOTICE:
When disposing of dust, also clean the
room for the dust bag/paper filter. The remaining
dust and dirt in the room may cause the sponge filter
to be clogged or the motor to be damaged.
1.
Push the button to open the front cover. Opening it
until a click is heard allows a positive stop at that position.
► Fig.32: 1. Front cover 2. Button
2.
Pull out both the orange-colored dust stopper and
dust bag/paper filter together at the same time.
► Fig.33: 1. Dust stopper
3.
Perform the procedures below depending on the
dust container type:
When using the dust bag
Remove the dust stopper and empty the dust bag.
► Fig.34: 1. Dust stopper 2. Dust bag
When using the paper filter
Remove the dust stopper and dispose of the paper filter.
► Fig.35: 1. Dust stopper 2. Paper filter
4.
Place the dust bag/new paper filter and dust stop-
per together into the cleaner and close the front cover.
NOTE: The cleaner is constructed in such a way that
the front cover comes off when trying to force the
front cover open at the angle of more than 90°. If the
front cover comes off, insert it into the front cover joint
in place.
► Fig.36: 1. Front cover 2. Front cover joint

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
After use
NOTICE:
Putting the cleaner against the wall
without any other support cause the cleaner to
fall down and be damaged.
► Fig.37
Cleaning
Cleaner body
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening, dust bag/paper filter
mounting area and the dust stopper.
► Fig.38
Dust bag
Wash the dust bag in soapy water when it is clogged with
dust and the cleaner power becomes weak. Dry it out thor-
oughly before use. An insufficiently dried filter may cause
poor suction and shorten the service life of the motor.
► Fig.39
NOTE: Paper filter is a throw-away type.
When the sponge filter is clogged with dust, remove it
from the cleaner and then wipe it off or wash in water.
Dust stopper
Wipe dust off from the dust stopper.
Remove dust and dirt on the sponge part by lightly tapping it.
► Fig.40: 1. Sponge part
Removing and installing the sponge filter
CAUTION:
After cleaning sponge filter, be
sure to install it on the cleaner. If washed in water,
dry it up before installing. An insufficiently dried
sponge filter may shorten the service life of the motor.
To remove the sponge filter, remove the dust bag or
paper filter and then pinch and take the sponge filter out.
► Fig.41: 1. Sponge filter
Press in the whole edge of the sponge filter against the
recessed wall inside the dust bag/paper filter mounting area.
► Fig.42: 1. Recessed wall
Wall mount for cordless cleaner
Optional accessory
NOTE: The screw to mount the holder is not included.
Prepare a screw which fits with the material to screw into.
Attach the wall mount for cordless cleaner to a hard wooden wall,
beam or column, where the wall mount for cordless cleaner can
be firmly secured. Always be sure that the wall mount for cordless
cleaner is securely attached before hanging the cleaner.
► Fig.43: 1. Wall mount for cordless cleaner
CAUTION:
Do not hang the cleaner to the wall
mount violently or hang other appliances than the
cleaner.
13 ENGLISH

Advertisement

Table of Contents
loading

Table of Contents