Minimum Clearances; Water Installation; Installation; Standard Installation On Finished Walls - STIEBEL ELTRON DCE-C 6/8 Trend Operation And Installation

iNSTallaTiON

installation
Note
f Install the appliance flush to the wall. The wall must f
have sufficient load bearing capacity.
8.2

Minimum clearances

≥50
f Maintain the minimum clearances to ensure trouble-free op- f
eration of the appliance and facilitate maintenance work.
8.3

Water installation

Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
f Flush the water line thoroughly. f
Taps
Use appropriate pressure taps. Open vented taps are not per-
missible.
Permissible water line materials
- Cold water inlet line:
Pipes made from galvanised steel, stainless steel, copper or
plastic
- DHW outlet line:
Pipes made from stainless steel, copper or plastic
Material losses
!
If plastic pipework systems are used, take into account
the maximum inlet temperature and the maximum per-
missible pressure.
Flow rate
f Ensure that the flow rate for switching on the appliance is f
achieved.
f If the required flow rate is not achieved when the draw-off f
valve is fully open, remove the flow limiter from the cold
water inlet.
If required, the pressure in the water installation can also be
raised.
6 | DCE-C Trend
≥50
9. Installation
factory settings
Connected load in kW
Standard installation
Electrical connection from below, installa-
tion on finished walls
Water connection, installation on finished
walls
For further installation options, see chapter "Alternative instal-
lation methods".
9.1

Standard installation on finished walls

Opening the appliance
f Open the appliance by undoing the screw and lifting up the f
appliance cover.
Preparing the power cable
A
f Prepare the power cable. f
position on finished walls
Bottom, centre
Bottom, left side of appliance
Bottom, right side of appliance
Top, right side of appliance
position on unfinished walls
Bottom
Top
DCE-C 6/8 DCE-C 10/12
Trend Trend
@ 220 V 8.0 12.0
@ 230 V 8.7 13.1
DCE-C 6/8 DCE-C 10/12
Trend Trend
x x
x x
B
Dimension a Dimension B
30 120
20 90
20 90
20 80
Dimension a Dimension B
20 90
20 80
www.stiebel-eltron.com