Water Installation On Unfinished Walls - STIEBEL ELTRON DCE-C 6/8 Trend Operation And Installation

iNSTallaTiON
alternative installation methods

12.5 Water installation on unfinished walls

You will need the appropriate accessories to carry out the in-
stallation. The installation kit for water installation on unfinished
walls contains:
- 2 x grommets to seal the apertures in the appliance back
panel.
- Strainer with sealed edge for installation on the 45° twin
connector.
- Flat gasket
In addition, you will need the flow limiter included in the appliance
standard delivery.
Preparation
f Insert and seal the 45° twin connectors. f
To break out the apertures in the appliance back panel, you will
need to remove the function module from the back panel.
3.
1.
2.
4.
5.
f Undo the screw and disengage the locking tab. f
f Push the function module on the back panel gently f
backwards.
f Remove the function module from the appliance back panel f
by pulling it slightly forwards and lifting it out.
10 | DCE-C Trend
f Push/break out the required apertures for the water connec- f
tions in the back panel from behind (for positions, see chap-
ter "Specification / Dimensions and connections"). Deburr any
sharp edges with a file.
1.
5
4.
4
1 Flow limiter
2 O-ring
3 Cold water pipe bend with recess for spring clip
4 Spring clip
5 Heater
f Remove the cold water pipe bend and the O-ring. f
f Insert the flow limiter (part of the appliance standard f
delivery) in the cold water inlet of the heater. Note the
orientation.
f Fit the cold water pipe bend with the O-ring. f
Material losses
!
The O-ring must be fitted to prevent the appliance from
leaking.
f As part of installation, check that the O-ring is in f
place.
f Secure the cold water pipe bend with the spring clip. f
Material losses
!
Ensure that the spring clip is located behind the recess
in the pipe bend and that it is securely holding the pipe
bend in place.
f Fit the function module in reverse order onto the appliance f
back panel until it clicks into place.
f Secure the function module with the screw. f
2.
3.
1 2 3
www.stiebel-eltron.com