Steps
1. Align the screw holes on the system fan with the screw holes on the display-assembly base.
2. Replace the three screws (M3x5) to secure the system fan to the display-assembly base.
3. Connect the system-fan cable to the connector on the system board.
Next steps
1. Install the
system-board
2. Install the
back
cover.
3. Install the
cable cover
(optional).
4. Install the stand.
5. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
cable cover
4. Remove the
back
cover.
5. Remove the
system-board
NOTE:
Removing the coin-cell battery resets the CMOS and BIOS settings to default and results in data lose. It is
recommended that you note the CMOS and BIOS settings before removing the coin-cell battery.
About this task
The following image provides a visual representation of the coin-cell battery removal procedure.
shield.
After working inside your
computer.
Before working inside your
(optional).
shield.
computer.
Removing and installing components
35