Cisco 7010 Replacement Instructions Manual page 11

Figure 6 Replacing the Fan Tray
Removing/replacing
fan tray
Step 6 Insert the top runner of the fan tray through the notch in the top of the chassis. Continue
pushing the tray into the chassis, and ensure that the bottom runner slides into the track on
the floor of the chassis. If the tray hangs up, pull it back out a few inches and try pushing it
in again. If the runners seem to be catching on the brackets, push the tray slightly toward
the left when inserting it again.
Slide the tray back into the chassis until the circuit board snaps into the backplane socket.
Step 7
Replace the M4 screw in the tab and tighten it with a number 2 Phillips screwdriver.
Step 8
600W AC-Input Power Supply and Fan Tray Replacement Instructions
Replacing Components
11