Information On The Illustrated Section; Symbols Used; Safety Instructions For Fitting; Safety Instructions - 4Ddoors GA103 Instructions For Fitting, Operating And Maintenance

safety reversal / reversing
Door travel in the opposite direction when the safety device or
power limit is activated.
travel
The distance the door takes to move from the Open end-of-travel
position to the Close end-of-travel position.
pre-warning time
The time between the travel command (impulse) and the start of
travel.
2.8

information on the illustrated section

The illustrated section shows how to fi t the operator on a
sectional door. Deviations for fi tting with an up-and-over door are
also shown. For this purpose, the following letters are assigned
to the fi gures:
(a) = sectional door
(b) = up-and-over door
2.9

symbols used

2.5
= Factory setting
3

sAfety instructions

wArning!
Follow all the instructions provided in this manual.
►
Install control devices at a height of at least 1.5 m (out of the
►
reach of children).
Fit permanently installed control devices (such as buttons,
►
etc.) within sight of the door, but away from moving parts.
Incorrectly fi tted control devices (e.g. buttons) may trigger
unwanted door travel. persons or objects may be jammed
as a result.
EBA GA103_4ddoors_GBR, Rev. 1.0, 25.04.2014.indb 5
= See text section 2.5
danger of injury due to
unwanted door travel!
Incorrect assembly or handling
of the operator may trigger
unwanted door travel that may
result in persons or objects being
trapped.
5
wArning!
danger of injury during door travel!
If people or objects are in the area around the door while the
door is in motion, this can lead to injuries or damage.
Children are not allowed to play near the door system.
►
Make sure that no persons or objects are in the door's area
►
of travel.
If the door system has only one safety feature, only operate
►
the garage door operator if you are within sight of the door's
area of travel.
Monitor the door travel until the door has reached the
►
end-of-travel position.
Only drive or pass through remote control door systems if
►
the door is in the Open end-of-travel position!
Never stay standing under the open door.
►
3.1 Safety instructions for fi tting
▪ The specialist carrying out the work must ensure that
installation is conducted in compliance with the prevailing
national job safety rules and regulations and those governing
the operation of electrical equipment. In the process, the
relevant national guidelines must be observed. Potential
hazards as outlined in DIN EN 13241-1 are avoided by
construction and fi tting according to our guidelines.
▪ The garage ceiling must guarantee secure fastening of the
operator. For ceilings which are too high or too light, the
operator must be fastened with additional struts.
▪ the mains plug must be disconnected before any work is
performed on the operator.
dAnger!
compensating springs are under high tension
Serious injuries may occur while adjusting or loosening the
compensating springs!
For your own safety, only have a specialist conduct work
►
on the door compensating springs and, if necessary,
maintenance and repair work!
Never try to replace, adjust, repair or reposition the
►
compensating springs for the counterbalance of the door or
the spring mountings yourself.
In addition, check the entire door system (joints, door
►
bearings, cables, springs and fastenings) for wear and
possible damage.
Check for the presence of rust, corrosion, and cracks.
►
A malfunction in the door system or an incorrectly aligned door
can cause serious injuries!
Do not use the door system if repair or adjustment work must
►
be conducted!
ENGLISH
5/26/2014 9:53:21 AM