External Receiver; External Impulse Button - 4Ddoors GA103 Instructions For Fitting, Operating And Maintenance

ENGLISH
6.2

external receiver

The functions impulse (OPEN-STOP-CLOSE-STOP-OPEN,
etc) or partial opening can be controlled with an external radio
receiver.
Plug radio receiver into the 4-pin base.
►
- Green wire (GN) → terminal 20 (0 V)
- White wire (WH) → terminal 21 (Channel 1)
- Yellow wire (YE) → terminal 23 (Channel 2)
- Brown wire (BN) → terminal 5 (+24 V)
 connector must engage properly!
See the manual of the receiver for information on teaching in
►
the remote control buttons to the receiver.
6.2.1 impulse function (channel 1)
All hand transmitter buttons programmed on channel 1 activate
the impulse function.
6.2.2 teaching in the partial opening function (channel 2)
A door position pre-set at the factory or any other door position
can be programmed.
Approx. 260 mm slide travel before the Close
end-of-travel position
Any At least 120 mm slide travel before each
end-of-travel position
All hand transmitter buttons programmed on channel 2 activate
the partial opening function.
EBA GA103_4ddoors_GBR, Rev. 1.0, 25.04.2014.indb 10
10
to teach in the pre-set position:
1. Programm a hand transmitter button on channel 2 of the
external radio receiver.
2. Move the door into the Open or Close end-of-travel
position.
3. Briefly press the circuit board button p twice.
(Pressing it three times will immediately end the process).
The red LED now flashes twice.
4. Press a taught-in hand transmitter button for channel 2.
If a valid radio code is detected, the red LED will flash
quickly.
5. Release the hand transmitter button.
the pre-set partial opening position is now
programmed.
The red LED flashes slowly (2x).
6. Press the circuit board button p once or wait for the
timeout.
The operator light is continuously illuminated.
timeout:
If no valid radio code is recognised within 20 seconds, the
operator automatically switches to operation mode.
to teach in any position:
1. Programm a hand transmitter button on channel 2 of the
external radio receiver.
2. Move the door into the desired position (but at least
120 mm before the end-of-travel position).
3. Briefly press the circuit board button p twice.
(Pressing it three times will immediately end the process).
The red LED now flashes twice.
4. Press a taught-in hand transmitter button for channel 2.
If a valid radio code is detected, the red LED will flash
quickly.
5. Release the hand transmitter button.
the chosen partial opening position is now
programmed.
The red LED flashes slowly (2x).
5. Press the circuit board button p once or wait for the
timeout.
The operator light is continuously illuminated.
timeout:
If no valid radio code is recognised within 20 seconds, the
operator automatically switches to operation mode.
6.3

external impulse button

Button P
LED red
One or more buttons with normally open contacts (volt-free),
such as internal push buttons or key switches, can be connected
in parallel.
5/26/2014 9:53:27 AM