Advertisement
3)
Valcom
One-Way
Assemblies (quantity and style determined
by specific installation).
Operation:
Follow
manufacturer's instructions for access to external
paging. Make your announcement. The V-2001 will
automatically disconnect when you hang up.
Background Music
Background music may be connected to the V -2001
when using any of the above configurations. The
background music will cut off on the "page + music"
outputs when the party making the page is speaking.
C. O. Audible Ring
and Time Clock Tone
C. O. audible ringing (electronic warble tone) over the
paging system is available when a common audible
contact closure or 90VAC ringing is supplied by the
telephone system.
A single tone over paging is provided when the V-
2001 is connected to a contact closure (time clock).
Battery Backup
The V-2001 is equipped with a standard 3 -prong
polarized MOLEX connector to allow the main unit
and a limited number of speakers to work with a fused
output (3 amp) battery backup supply (Valcom VPB-
260 or equivalent) in case of AC power failure.
Page Override
A page override feature is available on the V-2001. It
requires the use of a vacant C. O. line position or
vacant loop start trunk port for access in addition to
the page port, vacant C. O. line position or vacant
loop start trunk port used for primary access of the
V-2001.
Operation: Press the appropriate line key (electronic
key system) or dial the appropriate trunk access code
(PABX) for page override access.
immediately be connected to the paging speakers
(overriding any page in progress).
announcement.
The V-2001 will automatically
disconnect when you hang up, re-establishing the
overridden page announcement.
INSTALLATION
Precautionary Designations
Mounting
The V-2001 was designed for wall or table mounting.
When wall mounting this unit, secure it to wall studs
Amplified
Speaker
the
telephone
system
You will
Make your
or a suitable brace. (A plywood backboard 2' square
and at least 1/2" thick attached to wall studs would be
considered a suitable brace). Make certain the unit is
not mounted near heat sources or strong magnetic
fields.
Ascertain control and terminal strip
accessibility.
Four #10 x 3/4" cross-tip round head wood screws are
included for mounting. Fasten the top two screws at
the appropriate location on the mounting surface
(approximately 8-3/8" apart and parallel to the floor),
allowing the screwheads to protrude 1/8" to 1/4".
Place the chassis of the unit onto the screwheads at
the mounting slots.
screws and fasten through the remaining mounting
slots.
Complete the mounting by tightening all
screws.
Power Connections
The V -2001 is provided with a three conductor line
cord. After all required connections have been made,
plug the power cord into an appropriate AC wall
socket.
Volume Adjustments
There are two volume controls on the V-2001. One is
used to adjust the background music volume level. It
is located directly below the battery feed ON/OFF
switch and is screwdriver adjustable. (See Figure 2
for location).
The second is used to adjust the
warble/single tone volume level.
approximately 1" above the PAGE TIP screw terminal
connection and is manually adjustable. (See Figure 2
for location). Each volume control is set by turning it
clockwise
to
increase
counterclockwise to decrease the volume.
The sequence of volume level adjustments are as
follows:
__ a)
Page level: During initial system set up,
individual speaker volume controls on the
4
Posi- tion the two remaining
It is located
the
volume
and
Advertisement
