Kenwood DDX9907XR Instruction Manual page 89

3
Set each parameter as follows.
[HPF FREQ]
■
High Pass Filter adjustment. (When Front or
Rear is selected on the Speaker Select screen)
[LPF FREQ]
■
Low Pass Filter adjustment. (When
Subwoofer is selected on the Speaker Select
screen)
1
■ [Slope]*
Set a crossover slope.
■ [Gain]
Adjust the gain of the front speaker, rear
speaker, or subwoofer.
[TW Gain] *
2
■
Adjust the tweeter level. (When Front is
selected on the Speaker Select screen)
[Phase Inversion]*
■
Set the phase of subwoofer output.
Check [Phase Inversion] to shift the phase
180 degrees. (When Subwoofer is selected
on the Speaker Select screen)
* Only when "LPF FREQ"/"HPF FREQ" is set to
1
a mode other than "Through" in [Xʼover].
* Only when "Tweeter" is set to "Small",
2
"Medium", "Large" in [Speaker Setup].
* 3 Only when "Subwoofer" is set to a mode
other than "None" in [Speaker Setup].
3
When Speaker network is set to 3-way:
[FREQ] (High Pass)
■
High Pass Filter adjustment.
[HPF FREQ], [LPF FREQ] (Band Pass)
■
Band Pass Filter adjustment. (When Mid
Range Speaker is selected on the Speaker
Select screen)
[FREQ] (Low Pass)
■
Low Pass Filter adjustment. (When Woofer is
selected on the Speaker Select screen)
*
■ [Slope]* 1 2
Set a crossover slope.
■ [Gain]
Set the gain of each speaker.
[Phase Inversion]
■
Set the phase of tweeter, mid range, and
woofer output.
Check [Phase Inversion] to shift the phase
180 degrees.
* 1 Only when "LPF FREQ"/"HPF FREQ" (Band
Pass) is set to a mode other than "Through"
in [Xʼover].
* Only when "FREQ" (Low Pass) is set to a
2
mode other than "Through" in [Xʼover].
NOTE
• For how to switch to the 3-way speaker system,
see 3-way speaker system setup (P.87).
Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
Controlling Audio
89
English