Device Communication (Driver) Software Installation; Configuring The Hardware - Noraxon Ninox Series User Manual

Ninox Hardware User Manual
email or respond by phone with the Activation Code. Enter the provided
Activation Code to remove any restrictions on use.

5.8 Device Communication (Driver) Software Installation

The Ninox camera requires the IDS uEYE device driver which is pre-installed by the MR3 software
installation.

5.9 Configuring the Hardware

Before the Ninox can be used, the device software settings must be configured to adjust frame rate,
resolution, and other camera settings.
Step 1
Open MR3, typically listed under Noraxon ->
MR3
Click on the Hardware Setup Hardware Setup Hardware Setup button in the upper Hardware Setup
right-hand corner.
Step 2
Select the Ninox icon, within the 'New Device
column, and click on the Insert Insert button. Insert Insert
Note: Make sure the Ninox camera is attached to
the USB port of the computer.
(Rev B)
'New Device 'New Device' ' ' ' 'New Device
14