Related Manuals for Noraxon Ninox 125
Summary of Contents for Noraxon Ninox 125
- Page 1 Ninox Camera Quick Start Guide Ninox Camera Quick Start Guide Quick Start Guide Quick Start Guide Quick Start Guide (Rev A)
- Page 2 Contents will vary depending on the purchased package. Figure 1 - Ninox camera Figure 2 - USB3.0 cable with sync (part #CBL31) Ninox 125 (part #140) Ninox 300C (part #143) Figure 3 - MyoSync station (part #262) Figure 4 - USB cable for MyoSync station (CBL2)
-
Page 3: Hardware Installation
Ninox Camera Quick Start Guide 2 Hardware Installation 2.1 Hardware Setup Instructions Step 1 Insert CBL31 USB connector (USB3.0 micro b) into the USB3.0 receptacle on the camera. Tighten BOTH thumb screws to the secure CBL31 to the camera. Note: Failure to connect CBL31 to the camera with BOTH thumb screws can result in damage to the USB3.0 receptacle on the camera. - Page 4 Ninox Camera Quick Start Guide 2.2 Select and attach your lens (300C only) Select a lens based upon the field of view that is needed for your specific use-case. Refer to the Section 11.3 of the hardware manual for details on selecting the appropriate lens. The following fixed-focal length lenses are available for use with this camera: a.
- Page 5 Ninox Camera Quick Start Guide Step 1 Open the control panel by right clicking on the Start menu and clicking on Power Options. Power Options. Power Options. Power Options. Step 2 Navigate to the Additional power settings Additional power settings Additional power settings Additional power settings Step 3...
- Page 6 Ninox Camera Quick Start Guide Step 5 Find the USB Settings USB Settings - - - - > USB Selective > USB Selective USB Settings USB Settings > USB Selective > USB Selective Suspend Suspend menu and select Disabled Disabled Suspend Suspend Disabled...
- Page 7 Ninox Camera Quick Start Guide Graphics Card Driver The latest graphics card drivers need to be installed on the host computer to ensure proper function with the 3D graphics and video in MR3. Step 1 Open the Device Manager by right clicking the start menu and select Device Manager Device Manager Device Manager...
-
Page 8: Software Installation
1. Insert the MR3 USB flash drive into the PC 2. A menu will automatically pop up 3. Click on the Noraxon installation file and follow the Wizard’s instructions 4. After installation, an icon will be created on the desktop 4.2 Companion Software Activation... -
Page 9: Configuring The Hardware
Ninox Camera Quick Start Guide 5 Configuring the Hardware Step 1 Open MR3, typically listed under Noraxon -> Click on the Hardware Setup Hardware Setup button in the upper Hardware Setup Hardware Setup right-hand corner. Step 2 Select the Ninox icon, within the ‘New Device ‘New Device’... -
Page 10: Recording A Measurement
Ninox Camera Quick Start Guide Step 4 Click on OK (in the bottom of the dialog box) when done. 6 Recording a Measurement Step 1 Within the Home screen, click on the myoVIDEO module icon. Create a New Subject Select New Configuration New Configuration New Configuration New Configuration. -
Page 11: Viewing A Record
Ninox Camera Quick Start Guide 7 Viewing a Record To view a previously recorded record, select the Database Database Database tab. Records are organized by Project Database Project Project Project and Subject name. Double click on the record of interested to open the record in the Viewer Subject Viewer tab.