Table of Contents
Advertisement
STEP 1.
A.
Connect the two Upright Beams (#4) & (#1) by a Cross Brace (#2) in the mid-span.
them by two 3" bolts (#10), four 7/8" Washers (#11), one Plate Washer (#9), and two M10
Aircraft Nuts (#12) on each end of the Cross Brace.
B.. Place the Backrest Adjustment Bar (#5) between the two Upright Beams on the selected holes
to obtain desired incline of Backrest.
C. Insert the Weight Supports (#6) into the top openings of the Upright Beams (#4) & (#1).
Secure them with two M10 Knob bolts (#13) through selected holes to obtain desired height of
the Supports.
D. Insert the Safety Hooks (#15) & (#27) through the holes on the Weight supports (#6) and secure
the hooks with two Small aircraft Nuts (#16).
ASSEMBLY INSTRUCTION
-8-
Fasten
Advertisement
Table of Contents
