Control Panel Description; Description Of Signals On Display - Pentair NOCCHI CPS 10 Manual

GB
CHaPter 5
ProGraMMinG

5.1 CONTROL PANEL DESCRIPTION

The control panel is shown in picture below.
Press the START/STOP button to start and/or stop the pump

5.2 DESCRIPTION OF SIGNALS ON DISPLAY

When running normally (that is, in the absence of any alarms) press the MODE button to alternate the various displays available:
1. BAR/PSI - SYSTEM PRESSURE
• Current pressure, shown in large
numbers on the display
• Currently active set point (set 1 or
set 2), shown in small numbers on
the display
2. HZ - MOTOR FREqUENCY
• Current frequency of the pump in Hz
28
• Pressure unit of measurement
(bar or PSI)
• Frequency graph indicator
• Frequency graph indicator
• Indication: Day/Hour/Pressure/
Alarms/Faults/Advanced parameters
Frequency/Current/State of the pump.
• Indication of access to settings.
• Unit of measure of the displayed
parameter.
• Temperature alarm indication.
• Address module (Primary/Secondary).
• START/STOP/Reset key.
• Key to confirm the changes made.
• Key for cancelling the changes made
during setup.
• Parameters change pushbuttons.
• Display change pushbutton.
• Control type display icon.
• Indication of displayed SET-POINT.
• Operation LED (green)
Alarm/Fault (red).
• Line LED green.
• Graphic display of the frequency
supplied to the motor.
• Day of the week
• Master (P) or Slave (S), only for unit
configuration
• Day of the week