Programming Menu - Pentair NOCCHI CPS 10 Manual

3. A - ABSORBED CURRENT
• Current absorbed by the pump in
Ampere
4. HH:MM - TIME
• Time
5. COMPLEMENTARY PUMP STATUS (UNIT ONLY)
• STB" the complementary pump is
on standby
• "ON "the complementary pump is on
and regulating
The parameter displayed by default is pressure (BAR or PSI); after 10 minutes of displaying one of the other parameters the system
automatically returns to displaying pressure.

5.3 PROGRAMMING MENU

NOTE
The CPS module indicates with the symbol
NOTE
Press the SET button to save the set parameters and exit the programming mode.
NOTE
Press ESC to exit the programming mode without saving any of the changed parameters.
Functioning of the module is programmable using a series of parameters grouped into 4 sub-menus:
MENU DESCRIPTION
tiMe/DaY to enter the time and day of the week.
Set-Point to change the system pressure Set-Point.
aDVanCeD ParaMeterS (LeV.1) to change setting parameters.
inStaLLation ParaMeterS (LeV.2) to change system setting parameters.
NOTE
For a correct configuration, we recommend using the "installation" and "advanced" parameters with the machine on
STOP and connected to the power supply.
• Frequency graph indicator
• Day of the week
• "TOP" the complementary pump is
on and is at the maximum possible
frequency
the modification status of the parameter.
• Day of the week
• Frequency graph indicator
• < Alarm Code > the complementary
pump is in alarm (for a description of
alarm codes, please see Chpt. 6.0)
GB
29