Manual Start/Stop; History (Saved); Signals, Alarm Status; Signal Table - Pentair NOCCHI CPS 10 Manual

GB

5.5 MANUAL START/STOP

It is possible to manually stop the pump by pressing the START/STOP button: in this situation the display alternatively shows the
writing STOP. During STOP status the module is not operative unless the anti-lock mode is activated (TAB parameters - installation
parameters 5.3.4). The word "abl" will be displayed if the condition is active.
START/STOP sequence of buttons, push the STOP button
ATTENTION
Press the START/STOP button again to exit the STOP condition.
CHaPter 6
SiGnaLS, aLarM StatUS anD errorS

6.1 HISTORY (SAVED)

Key sequence:
Press ESC for 5 seconds.
Press MODE to scroll the error log.
Press STOP to see the hour and the date of the event (when the clock has been set correctly).

6.2 SIGNAL TABLE

MESS. DISPLAY DESCRIPTION
init System initiation signal.
rein System re-initiation signal.
iniB inhibitor intervention signal.
rPC reset configuration.
reC Saving parameter signal.
rSt total reset signal.
rSe Memory reset.
eSG Memory reset carried out.
FaL end of alarm (in memory).
toP Maximum power complementary pump.
on Complementary pump on.
StB Complementary pump on standby.
34
the condition occurs when the system is first
started-up or after a prolonged power failure.
the condition occurs when a short power failure
takes place.
this is an operative condition generated by an
external command which closes entry to the
inhibitors. (no – nC)
ACTION
Wait for a change in status.
Check the external inhibitor command
(i.e. switch, float, pressure gauge).
the board has been reset. the cause of this signal can be a either
prolonged absence of power or if the reset button has been pressed
manually. the module will save all the information recorded, with
the exception of clock setting.
the eeprom memory has been reset (see chapter 7.2). the module
returns to the factory settings.
Confirms that the eeprom memory has been reset (see chapter 7.2).
indicates the end of an alarm.
the complementary pump is on at the maximum frequency possible.
the complementary pump is on and regulating.
the complementary pump is on standby.