Honda WAVE ALPHA Owner's Manual page 89

8. Remove the rear axle shaft, drive chain
adjusters, side collars and rear wheel from
the swingarm.
Drive chain adjuster
Rear axle
shaft
Installation
1. To install the rear wheel, reverse the
removal procedure.
2. Tighten the rear axle nut.
Torque: 59 N·m (6.0 kgf·m, 44 lbf·ft)
Drive chain
adjusting nut
Drive chain
Drive chain lock nut
Tyre Puncture
3. Tighten the brake stopper arm nut.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft)
4. Adjust the rear brake pedal freeplay.
5. Adjust the drive chain slack.
6. After installing the wheel, apply the brake
pedal several times and then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
A used cotter pin may not effectively secure a
fastener. Always replace a used cotter pin with
a new one.
Removing Wheels
u
P.
64
2
P. 70
2
85