Honda WAVE ALPHA Owner's Manual page 85

Installation
1. Install the side collar into the right side
wheel hub.
2. Position the wheel between the fork legs
and insert the front axle shaft from the right
side, through the right fork leg and wheel
hub.
3. Make sure that the lug on the left fork leg is
located in the slot of the brake panel.
4. Tighten the front axle nut.
Torque: 59 N·m (6.0 kgf·m, 44 lbf·ft)
5. Install the speedometer cable securely.
6. Install the front brake cable and front brake
adjusting nut.
7. Adjust the front brake lever freeplay.
8. After installing the wheel, apply the brake
lever several times and then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
Brake panel
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
P.
62
2
Improper assembly may lead to loss of
braking capacity.
Tyre Puncture
Removing Wheels
u
Lug
Slot
continued 81