Operation - Greenlee 39693 Operation, Service And Parts Instruction Manual

Operation

Punching Bus Bar
Pinch points. Do not remove
guards. Keep hands away from
moving parts.
Use the Die Alignment procedure frequently.
Through normal use of the bus bar punch, the die
may become out of alignment. Using the bus bar
punch with the die misaligned will produce burrs
on the bus bar and may eventually damage the
punch and the die.
Failure to observe this precaution could result in
damage to the tool.
1. Insert the bus par into the bus bar punch.
2. Use the alignment table or the X-Y table (optional)
to set the bus bar in the appropriate location.
Note: The scale on the back stop, alignment guide,
and centering guide measure the distance to the
center of the punch. If using the alignment table,
see Figures 3 and 4. If using the X-Y table, see
Figures 4 and 5: Hole Patterns for X-Y Table.
•
TABLE SCALE (-100 mm thru 100 mm): Indicates distance
from punch center
•
BACK STOP SCALE (0 thru 100 mm): Indicates distance
from end of work piece to punch center
•
TO SET X-Y PATTERN:
Place pin in either slot 1, 2, 3, or 4
Locate shoulder screw on underside of table
position screw in either slot A or B
"X" DIRECTION
PIN DIM
POSITION "A"
17 mm
Slot 1
(.67")
30 mm
Slot 2
(1.18")
25 mm
Slot 3
(.98")
20 mm
Slot 4
(.74")
Greenlee Textron / Subsidiary of Textron Inc.
Bus Bar Punch System
Figure 5 — Hole Patterns for X-Y Table
"Y" DIRECTION
SHOULDER
DIM DIM
SCREW
"B" "C"
POSITION
26 mm Slot A 26 mm (1.02")
(1.02")
Slot B 40 mm (1.57")
26 mm (1.02")
60 mm Slot A
(2.36")
Slot B 40 mm (1.57")
Slot A 26 mm (1.02")
50 mm
(1.97")
Slot B 40 mm (1.57")
Slot A 26 mm (1.02")
40 mm
(1.57")
Slot B 40 mm (1.57")
Figure 3
Back Stop Scale
0-12 cm
Reads distance from
punch center at rear edge.
Figure 4
3. Use the hydraulic pump to advance the ram.
Note: Refer to the manual supplied with the pump.
4. Release the hydraulic pressure. Move the bus bar
to the next punching position. Repeat steps 2- 4.
SLOT 1
SLOT 2
SLOT 3
SLOT 4
PIN
7
4455 Boeing Dr., Rockford, IL 61109-2988
Centering Guide
0-120 mm
Alignment Guide
80-220 mm
Reads distance from
punch center
A B
Y
X
C
BACK STOP SCALE
PUNCH CENTER
TABLE
SCALE
SLOT B
SLOT A
SHOULDER SCREW
DECAL NO. 503 9710.9 REV 1
815/397-7070