Table of Contents
Advertisement
Safety Information
The symbol above is used to call your attention
to instructions concerning your personal safety.
Watch for this symbol. It points out important safety
precautions. It means "ATTENTION! Become alert!
Your personal safety is involved!" Read the
message that follows and be alert to the possibility
of personal injury or death.
Safety is a critical factor in the design of Greenlee equipment. The best program starts with a safety-conscious
operator. The information highlighted in this bulletin describes operating practices for the benefit of the workers
who will use our equipment in their daily jobs. Comments from users are appreciated.
• Disconnect electric pump from power supply
before changing accessories, making adjust-
ments, or servicing. Accidental start-up could
result in severe injury.
• Inspect the tool before using. Replace any
worn, damaged, or missing parts with Greenlee
replacement parts. A damaged or improperly
assembled tool can break and strike nearby
personnel with sufficient force to cause severe
injury or death.
Pinch points. Do not remove
guards. Keep hands away from
moving parts.
Greenlee Textron / Subsidiary of Textron Inc.
Bus Bar Punch System
SAFETY
ALERT
SYMBOL
Immediate hazards which, if not avoided, WILL result in
severe personal injury or death.
Hazards or unsafe practices which, if not avoided, COULD
result in severe personal injury or death.
Hazards or unsafe practices which, if not avoided, COULD
result in minor personal injury or property damage.
• The yoke pin unit must fully engage the punching
yoke. An improperly assembled tool could break
and components could strike nearby personnel.
• The punch unit is heavy, weighing over 90 lbs.
(40.9 kg), and may require more than one person
to lift or assemble. Injury could result from lifting
alone. If in doubt, get help.
Failure to observe these warnings could result in
severe injury or death.
• The punch unit is not designed to completely
support longer bus bar. Use additional support
when punching bus bar 1 meter long or longer.
Failure to support bus bar may damage punch unit.
• Use the Die Alignment procedure frequently.
Through normal use of the bus bar punch, the die
may become out of alignment. Using the bus bar
punch with the die misaligned will produce burrs
on the bus bar and may eventually damage the
punch and the die.
Failure to observe these precautions could result in
injury or property damage.
3
4455 Boeing Dr., Rockford, IL 61109-2988
815/397-7070
Advertisement
Table of Contents
