Operation - Blodgett SN-3E Installation, Operation And Maintenance Manual

3.0 OPERATION

When set to ON, your steamer has been factory set to maintain the generator standby
temperature just below the boiling point, approximately 205°F, in READY mode.
CONTROLS
Ready Light
Cooking Light
Timer
Main Power Switch
ON
OFF
DELIME
OPERATION
1. When READY light comes on, preheat compartment for about one minute when steamer is
to be first used for the day or whenever the chamber is cold. Make sure compartment door
is closed.
2. When buzzer sounds, set time to OFF position. Your steamer is now ready for cooking.
3. With compartment preheated and READY light ON, place pans of food into the compartment
and close the door.
4. Set timer to desired cooking time. (The cooking cycle may be interrupted at any time by
opening the door. To resume operation, close the door.)
5. At the end of the cooking cycle, the buzzer will sound, the COOKING light will go off and
steam supply to the compartment will cease. Turn the timer to the OFF position to silence
the buzzer.
WARNING: Live steam and accumulated hot water in the compartment
may be released when the door is opened.
- when lit, indicates steam generator has reached 205 degrees
Fahrenheit and is ready for the cooking cycle.
- when lit, indicates that a cooking cycle is in progress
- set the cooking time (0 to 60 minutes) - steam cooking will begin when
the door is closed. The cooking cycle will be interrupted if the door is
open during the cooking cycle; resume cooking by closing the door.
- when turned ON, boiler will automatically fill with water and begin
heating to READY temperature.
- The boiler will drain.
- Closes the drain valve while CLR liquid is being poured into the
generator during the delime procedure.
11