KVH Industries TracPhone V7 Replacement Instructions page 3

f. Using a 3/8" nut driver or wrench, remove the three
#10-32 lock nuts and flat washers securing the bottom
of the PCB cover to the antenna frame. Remove the
cover.
NOTE: Be sure to handle the cover carefully to avoid damaging or
dislodging PCB components.
g. Carefully disconnect the eight wire connectors from the
PCB.
Figure 3 Removing the PCB
#6-32 Socket-head
Cap Screw (x9)
h. Using a 7/64" allen wrench or hex driver, remove the
nine #6-32 socket-head cap screws securing the PCB to
the antenna frame (see Figure 3). Remove the PCB.
i. Attach the replacement PCB with nine new #6-32
screws (supplied in the kit).
j. Reconnect all eight wire connectors.
k. Carefully reattach the PCB cover.
l. Reconnect the GPS and RF cables. Be sure to connect
the cable with the right-angle connector to the left-hand
connector on the PCB (see
m. Reinstall the radome.
n. Plug in the modem and control unit.
PCB Replacement Instructions
Wire Connector (x8)
Figure 2 on page 2).
TracPhone V7
3