KVH Industries TracPhone V7 Replacement Instructions page 2

TracPhone V7
PCB Replacement Instructions
Step 1 - Replace the PCB
2
a. Turn off and unplug the modem and control unit.
b. Using a #2 Phillips screwdriver, remove the #10-32
screws securing the radome to the baseplate. Carefully
lift the radome straight up until clear of the antenna
assembly and set it aside in a safe place.
Figure 1 Removing the Radome
#10-32 Screw
c. Using a 7/16" open-end wrench, carefully disconnect
the two RF cables from the PCB. To avoid stressing the
cables, hold the top of the connector while loosening.
Figure 2 Detaching the PCB Cover
GPS Cable
#10-32 Screw (x3)
d. Disconnect the GPS cable (RJ11) from the PCB.
e. Using a #2 Phillips screwdriver, remove the three
#10-32 screws securing the top of the PCB cover to the
antenna frame.
RF Cable (x2)
Right-angle
connector
#10-32 Lock Nut and
Flat Washer (x3)