PARTS LIST Please read through the instructions carefully PART COMPONENT before assembly. 3 Sets Please check all components are present of poles and have no defects. Never climb or swing on the poles or net. 1 net This product is not a toy, serious injury can occur 1 end Panel if the product or it’s components are misused.
Page 3
Step 2 Tie 6 guy lines to the loops on the pole sleeves Tie guy lines to Pole sleeves Extra guy lines If required, 2 extra guy lines can be added to the ends of the cage Step 3 Assemble the fibreglass poles and thread one through each of the pole sleeves..
Page 4
Once the poles have been threaded through the sleeves locate the pins that are attached to the net into the holes at the end of the poles. Step 4 Ensure cage is straight and in the desired position then hook guy lines to the pegs and tap pegs into the ground.
Page 5
Step 5 Once the cage is fixed to the ground, if required attach the end panel using the toggles around the frame of the net to fully enclose the cage. Additional steps. It is possible to remove the centre floor strap to avoid bowling or pitching on to it. Simply unclip the strap from the frame on each side.