Water Condensation Drainage - Honeywell MN Series User Manual

CLEANING & MAINTENANCE (CONTINUED)
5. Disconnecting the Window Installation Kit:
• Remove the Exhaust Hose from the unit by pulling away from the unit at the same time.
•
Remove the Window Bracket, Window Bracket Panel Adapter and Exhaust Hose Connector.
•
It is recommended to store the Window Kit parts in a bag together with the Remote Control
and placing them together with the air conditioner unit.
• If needed, you can clean the Window Kit with a damp cloth and water before storing.
Make sure all parts of the Window Kit are dry before storage.
6. Cover the air conditioner with a cloth/plastic bag before storage, to protect from dust and
scratches collecting on the surface of the unit.
7. It is recommended to coil the power cord before storing to ensure the cord is protected from
bents and creases.
8. Store the air conditioner in a cool, dry place, away from direct sunlight.

WATER CONDENSATION DRAINAGE

When there is excess water condensation inside the unit, the air conditioner stops running and
shows a warning light (the Power Control button flashes with a red light). This warning light indicates
that the water condensation needs to be drained using the following procedures:
Manual Draining in Cooling, Dehumidifying and Heating* Modes
Water may need to be drained in high humidity areas.
1. Unplug the unit from power source.
2. Place a shallow pan under the lower rubber drain plug.
See diagram.
3. Remove the lower rubber drain plug.
4. Water will drain out and collect in the shallow pan.
5. After the water is drained, replace the lower rubber
drain plug firmly.
6. You can now turn on the unit.
Plastic Cap
and Lower
Drain Plug
*Applicable for models with Heating feature only.
EN 12
Shallow Pan
(Not included)