Table of Contents
Advertisement
WATER CONDENSATION DRAINAGE
When there is excess water condensation inside the unit, the air conditioner stops running and
shows a warning light (the Power Control button flashes with a red light). This warning light indicates
that the water condensation needs to be drained using the following procedures:
Manual Draining for AC & Dehumidifier Mode
Water may need to be drained in high humidity areas.
1.
Unplug the unit from power source.
2.
Place a shallow pan under the lower rubber drain plug.
See diagram.
3.
Remove the lower rubber drain plug.
4.
Water will drain out and collect in the shallow pan.
5.
After the water is drained, replace the lower rubber
drain plug firmly.
6.
You can now turn on the unit.
Continuous Draining for Dehumidifier Mode
While using the unit in dehumidifier mode, continuous
drainage is recommended.
1.
Unplug the unit from power source.
2.
Remove the upper/lower rubber drain plug.
Some residual water may spill so please have a pan to
collect the water. See diagram.
3.
Connect the drain connector to a ¾" Hose or standard
garden Hose (not included).
4.
The water can be continuously drained through the
drain tube into a floor drain or bucket.
5.
Replace the drain plug.
6.
You can now turn on the unit.
Shallow Pan
(Not included)
EN
12
Lower Rubber
Drain Plug
(External Diameter
14mm)
Upper Rubber
Drain Plug
(External Diameter
23.5 mm)
Drain Tube
Advertisement
Table of Contents
