Honeywell MN Series User Manual page 14

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
TIMER CONTROL
While the unit is turned on, press the timer button then press the
hours you would like the unit to continue to run. The unit will turn off automatically.
AUTO TURN OFF:
While unit is running, press the
in air conditioning mode.
AUTO TURN ON:
When unit is in a standby mode (plugged in with power light on), then press the
select the number of hours until you want the unit to automatically start running.
TEMPERATURE / TIMER SET CONTROLS
• Used for adjusting the timer and thermostat.
• The default display is setting temperature.
• In cooling mode, when
adjusted. After 10 seconds the display will revert back to room temperature. Temperature is only
adjustable in cool mode. The time is adjustable between 1 - 24 hours.
Note: By pressing both
Celsius (°C) and Fahrenheit (°F).
WARNING LIGHT
Condensation may accumulate in the unit.
If the internal tank becomes full, the Power Control light will flash and the unit will not operate until
the unit has been drained (refer to Water Condensation Drainage).
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
or button to select the number of hours you want the unit to run
▼ ▲
or button is pressed, the set temperature is displayed and may be
▼ ▲
or buttons at the same time, the display will toggle between
▼ ▲
EN
or
▼ ▲
9
to select the number of
▼ or ▲ button to