LevelOne FCS-5044 User Manual page 28

Network Camera User's Manual
"LAN" & "PPPoE"
The default type is LAN. Select PPPoE if using ADSL
1. LAN
The default status is Get IP address automatically. This could be tedious to perform
software installation whenever the Network Camera starts. Therefore, once the network
is set, especially for the IP address should be entered correctly. Select Use fixed IP
address then the Network Camera will skip installation. The Network Camera will
automatically restart and operate normally after a power outage. You can run IP installer
to check the IP address assigned to the Network Camera if the IP address is forgotten,
or you can use the UPnP function provided by the Network Camera (MS Windows XP
provides UPnP function at My Network Place).
(1) "Get IP address automatically"
(2) "Use fixed IP address"
- "IP address":
- "Subnet mask":
subnet. The default value is ―255.255.255.0‖.
- "Default router":
different subnet. Invalid router setting will fail the transmission to destinations in
different subnet.
- "Primary DNS":
into IP addresses.
- "Secondary DNS":
2. PPPoE
If using the PPPoE interface, you should fill the following settings from ISP.
(1) "User name": The login name of PPPoE account
(2) "Password": The password of PPPoE account
(3) "Confirm password": Input password again for confirmation
Port parameters setting
- "Http Port"
This can be typed besides the default Port 80. Once the port is changed,
the users must make sure the change for the connection is successful. For instance,
when the Administrator changes the HTTP port of the Network Camera which IP
address is 192.168.0.20 from 80 or 1025 to 65535, the users must type in the web
browser ―http://192.168.0.20:8080‖ instead of ―http://192.168.0.20‖.
- "Https Port"
By default, the HTTPS port is set to 443. It can also be assigned to
another port number between 1025 and 65535.
- "RTSP Port"
RTSP port can be typed besides the default Port 554.
- "Video RTP Port"
This is necessary for network identification.
This is used to determine if the destination is in the same
This is a gateway used to forward frames to destinations in a
The primary domain name server that translates hostnames
Secondary domain name server backups the Primary DNS.
Advanced Mode
Video RTP port can be typed besides the default Port 6790.
28/63