Advertisement
Quick Links
INSTALLATION
1. Turn off gas and electric to unit. Take unit out of the
fireplace if applicable.
2. Remove 4 screws and remove outer top, repeat for other
side. Set parts aside, they will be re-used. See Figure 1.
3. Remove 6 screws to blower assembly and disconnect
wire harness to blower. Discard blower assembly, it will
not be needed. See Figure 2.
42035-0-0420
INSTALLATION INSTRUCTIONS
BLOWER & LIGHT REPLACEMENT KIT
FOR USE ON: DVCT30 AND DVCT35 DASH-1 UNITS
Figure 1
Figure 2
Empire Comfort Systems Inc. • Belleville, IL
4. Remove 7 screws and remove outer rear assembly.
Discard this assembly, it will not be needed. See
Figure 3.
5. Remove 3 screws and remove outer left side. Discard
this part, it will not be needed. See Figure 4.
Figure 3
Figure 4
Page 1
Advertisement
Related Manuals for Empire DVCT30
Summary of Contents for Empire DVCT30
- Page 1 INSTALLATION INSTRUCTIONS BLOWER & LIGHT REPLACEMENT KIT FOR USE ON: DVCT30 AND DVCT35 DASH-1 UNITS INSTALLATION 4. Remove 7 screws and remove outer rear assembly. Discard this assembly, it will not be needed. See 1. Turn off gas and electric to unit. Take unit out of the Figure 3.
- Page 2 3 screws. Remove top liner and set these items aside, they will be re-used. See Figure 6. POWER WIRES NOT SHOWN — LIGHT Figure 6 LIGHT WIRES WIRES Figure 8 LIGHT WIRES Page 2 Empire Comfort Systems Inc. • Belleville, IL 42035-0-0420...
- Page 3 13. Re-attach slide plate with 2 bolts, you may choose to do this step at a later time. This will depend on your install. See Figure 10. Figure 12 Figure 10 42035-0-0420 Empire Comfort Systems Inc. • Belleville, IL Page 3...
- Page 4 It is recommended to check for leaks at box. See Figure 14. this time. The rework has been completed at this time. Figure 14 Empire Comfort Systems Inc. Belleville, IL If you have a general question about our products, please e-mail us at info@empirecomfort.com.