Notify your sales representative if any of the above items are missing or damaged. Hardware Introduction As shown in the following figures, NPort P5150A series of device servers have one male DB9 port for transmitting RS-232/422/485 serial data. Reset Button—Press and hold the Reset button for 5 seconds to load factory defaults: Use a pointed object, such as a straightened paper clip or toothpick, to depress the reset button.
Page 3
WARNING 1. The equipment is designed for in-building installation only and is not intended to be connected to exposed (outside plant) networks. 2. This equipment is intended to be used in a Restricted Access Location. 3. This product is intended to be supplied by an UL60950-1 and IEC60950-1 certified Power Unit marked “LPS”...
Hardware Installation Information STEP 1: After removing the NPort P5150A device server from the box, if you are not using a PoE switch, the first thing you should do is connect the power adaptor. STEP 2: Connect the NPort P5150A device server to a network. Use a standard straight-through Ethernet cable to connect to a PoE switch.