Huawei RTN 360 V100 Quick Installation Manual page 8

References for Installation
Optional: Installing an RTN 360 on a Pole
Pass the hose clamps through the fastener and use the
screws provided to secure the hose clamps onto a pole.
This side up
Optional: Installing an RTN 360 on a Wall
Press the fastener against a wall, level the installation location
using a level, and mark locating points using a marker.
1. Fastener
2. RTN 360
Drill holes and install expansion bolts at the locating points.
1. M6x60 bolt
2. Nut
3. Spring washer
4. Flat washer
5. Expansion sleeve
Rubber mallet
14/15 >>
Before securing the hose clamps, ensure that the
azimuth angle faces the peer site.
Install the fastener onto the expansion bolts, place a flat washer, a
spring washer, and a nut on each expansion bolt, and then tighten
the nuts.
Wall
Wall
Ensure that each expansion bolt protrudes from 8
mm to 12 mm.
Install the RTN 360 box securely on the fastener.
Hook the RTN 360 box (with the attachment plate
installed) to the fastener along the dowel.
Install the RTN 360 box securely on the fastener.
Hook the RTN 360 box (with the attachment plate
installed) to the fastener along the dowel.
Tighten the azimuth
adjustment wing nut using a
hex key.
Tighten the azimuth
adjustment wing nut using a
hex key.