Advertisement
Quick Links
H-2901, H-2902, H-2903
π
H-2904, H-2905, H-2906
H-2907, H-2908
SLIDING STORAGE
SHELVES
in addition to the posts, shelves, levelers and shelf supports from the
Adjustable Open Wire Shelving, this kit includes the following:
ShElvinG Unit
1.
Make sure post is positioned as shown. (See Figure 1)
2. Use a rubber mallet to tap levelers into posts.
(See Figure 1)
3. Unscrew and remove the bolts from the levelers.
Figure 1
PAGE 1 OF 3
1-800-295-5510
uline.com
End track x 4
Middle track x 2-6
Adjustable Pin x 6-10
PARTS
Stop x 4
ASSEMBLY
4. Start with the lowest shelf. Snap the interlocking
pieces of a shelf support (wide end down) around
the post at the lowest groove where shelf is to be
located. Slide the support up or down until it snaps
into the groove. Add a shelf support to the same
place on the remaining posts. (See Figure 2)
NOTE: NSF requires food service applications to
keep the lowest shelf at least 6" above the floor.
Bolt x 8
Allen Key x 1
Roller Assembly x 6-10
Figure 2
0814 IH-2901
Advertisement
Related Manuals for U-Line H-2901
Summary of Contents for U-Line H-2901
- Page 1 H-2901, H-2902, H-2903 π H-2904, H-2905, H-2906 1-800-295-5510 H-2907, H-2908 uline.com SLIDING STORAGE SHELVES PARTS in addition to the posts, shelves, levelers and shelf supports from the Adjustable Open Wire Shelving, this kit includes the following: End track x 4...
- Page 2 ASSEMBLY CONTINUED SliDinG tRACK 5. Slide posts through underside of shelf until shelf slides firmly over supports. (See Figure 3) 1. Attach stops to the ends of the tracks using two bolts. (See Figure 6) Figure 3 Figure 6 6. Stand unit upright. Gently tap shelf down to secure it. (See Figure 4) 2.
- Page 3 ASSEMBLY CONTINUED 4. Place roller assemblies on track. (See Figure 9) 5. Carefully place the shelving units on the pins of the roller assemblies. Pins should fit inside the inserts in NOTE: Roller brake should face outwards. the bottoms of the posts. (See Figure 10) Figure 9 Figure 10 π...