Advertisement
SPINDLE AND SUPPORT ARM "TEE" BEAM ASSEMBLY [H] & [D] TO
MAIN SUPPORT FRAME & SPINDLE SUPPORT ASSEMBLY [A] & [E].
1. Remove the Retaining Clip and Washer from the Spindle Latch Pin and
set aside for reinstallation.
2. Apply a liberal amount of high-quality synthetic, high-load wheel
bearing grease or an anti-seize compound to the bearing surfaces of
the Spindle Support and outside of the Spindle before insertion.
The assistance of a capable assistant is required for
the following step.
3. Lift the Spindle and "Tee" Beam Assembly [H] and [D] and insert the
Spindle into the Sleeve. Push it in fully engaging the Latch Pin with the
hole nearest the 12:00 position of the 10 in the Rotation Lock Plate
(FIG 17).
4. Reinstall the previously removed Retaining Clip and Washer onto the
Spindle Latch Pin (FIG 17).
5. Slide the Spindle Retaining Collar [J] over the protruding inboard end
of the Spindle [H] and align the through holes (FIG 18).
6. Insert the Spindle Rotating Bar [K] through the Spindle Retaining
Collar [J] and the Spindle [H] (FIG 19).
7. Push the rubber Spindle Rotating Bar Grips [L] fully onto the ends of
the Spindle Rotating Bar [K] (FIG 20).
8. The assembly should appear as in FIG 21. Repeat assembly procedure
for opposite end.
FIG. 19
K
FIG. 20
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 17
FIG. 18
J
FIG. 21
L
H
E
9
Advertisement
