Advertisement
JOIN ROTISSERIE HALVES
Note once again that the two Rotisserie end assemblies are mirror images
of one another (FIG 22).
Do Not allow any of the telescoping Beams [B], [M],
[N] & [P] to extend beyond the marked minimum
insertion lines or collapse can occur.
1. Arrange each Rotisserie half assembly on the floor with the open
beams facing another and resting solidly on their casters (FIG 22).
2. Slip the non-lockbolt end of each of the two Large Connector Beams
[M] into the two arms of the Rotisserie half assembly. Do Not allow
the Beam to extend beyond the minimum insertion lines marked at
4" [10cm] from the Beam end (FIG 23). Lightly tighten the Lockbolt
with a 21mm wrench (not included) to keep Beam from sliding.
3. Slide the non-lockbolt end of each of the two Intermediate Connec-
tor Beams [N] into the ends of the Large Connector Beams [M]. Do
Not allow the Beam to extend beyond the minimum insertion lines
marked at 4" [10cm] from the Beam end (FIG 24). Lightly tighten
the Lockbolt with a 21mm wrench (not included) to keep Beam from
sliding.
4. Slip the non-lockbolt end of each of the single Small Connector
Beam [P] into the ends of the Intermediate Connector Beams [N].
Do Not allow the Beam to extend beyond the minimum insertion lines
marked at 4" [10cm] from the Beam end (FIG 24). Lightly tighten
the Lockbolt with a 21mm wrench (not included) to keep Beam from
sliding.
5. Apply a liberal amount of high-quality synthetic, high-load wheel
bearing grease or an anti-seize compound to the Jackscrew acme
threads before use.
10
FIG. 22
FIG. 23
FIG. 24
M
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
Maximum
Extension
N
P
N
M
Advertisement
