Troubleshooting - Kellfri 13-VM360E Instructions Manual

SERVICE INTERVAL
Oil Exchange after 10 h
Thereafter every 50 h
or once a year
Bolts and nuts Check regularly, preferably before each use
Moving parts Regularly
Chainsaw Regularly

TROUBLESHOOTING

ERROR
The piston is not moving
forward
The machine doesn't start
The machine don't have
the power
Chainsaw is not working
The infeed conveyor
doesn't move forward
18
PROBABLE CAUSE
Low or no pressure in the system
The engine rotates the wrong way
Fault with the power source
The machine is not correctly plugged
Low or no pressure in the system
The machine is not plug
The belt is not correctly tightened
or broken
ACTION
Oil Change
• Use hydraulic oil ISO 32 or 46
• Draining the tank is done by removing
the drain-plug under the tank.
• Fill through the filler plug on top.
Check and retighten all bolts and nuts
Lubricate moving parts on a regular basis
Check the condition of the following parts:
Gear: check for abrasion and/or cracks
Guide bar: Check for abrasion.
Chain: The cutting links must be kept sharp
for the machine to cut efficiently. Sharpens if
requires.
ACTION
Check oil pressure and level. check if there's
a leak age in the system.
Check the engine rotation and reverse if
requires
Check the power source
Check and plug the machine correctly.
Check if there's leakage in the system.
Check all couplings and hydralic hoses.
Check and connect.
Check the conveyor belt. Replace or tighten
if necessary