Kellfri 13-VM360E Instructions Manual page 7

SAFETY MEASURES BEFORE OPERATING
Read the safety information and instruction manual carefully. Be sure you understand the
safety measures, instruction manual and warning labels. Use common sense when operating
the machine and use appropriate personal protective equipment.
Always check the performance and the machine combination that are used. It's highly impor-
tant these matches in a satisfactory manner. This is to ensure the product or the function and
most important yours and others safety.
Do visual inspection of equipment or product before use. Fix or replace damaged or worn
parts immediately to reduce the risk of injury. Lubricate moving parts and check that all screw-
nuts and bolts are tightened.
Learn and remember the correct working methods. Beginners should keep a low speed until
the person has learn the proper use of the machine/product. The user/customer is responsible
to handle the situation correctly. Do not use the machine if it is experienced to be dangerous
for the user.
• Check the working area, the object to be cut and the cutting direction.
• Before you begin cutting, make sure that the working area is cleared.
• Take care and keep bystanders and animals away from the area within 5m in diameter.
• Make sure the machine is not worn out, have loose or damaged parts. Do not use if damaged,
incorrectly, or if not installed correctly. Make sure the sawchain stops moving when the
throttle is released.
• The machine is supplied with three-pole plug CEE 32A. The plug according to the law
must be connected to a corresponding outlet, which should be installed by a qualified
electrician.
• The machine is tested before shipping and delivered filled with hydraulic oil SHS 32, mo-
tor protection and mounted terminal glove.
• Place the machine on a flat, stable surface. Make sure it cannot roll or overturn.
• Familiarize and study how the machine works without starting it.
• Always test the emergency stop before each use. Start the machine and press the emer-
gency stop, the machine should be shut off at once, do not use the machine if this does
not occur. The machine must not be used until the fault is rectified.
• Test safety switch: Start the machine, pull the load device and remove the protective cap
over the splitting part of the machine, the machine will then shut off automatically. Do
not use the machine if this does not occur, the machine must not be used until the fault
is rectified.
7