Kellfri 13-VM360E Instructions Manual page 13

Chain oil
Open the tap of the chain oil tank before
starting. Turn off the tap when not in use
to prevent chain oil leakage.
Change the start time
To change the start time (current limiter)
turn the knob to the desired number of
seconds. Suggestion about two to five sec-
onds.
Start and Stop:
To start the machine, press the green but-
ton. To stop the machine push the red but-
ton, this is also the emergency stop.
Setting
It is important to set the lifting and lower-
ing speed of the chainsaw before you start
cutting firewood. Run the machine a num-
ber of times without placing any wood to
get the right speed of the bar. Start with
a low speed and increase a bit afterwards,
check that the chainsaw cut easily through
the wood. If the speed is too high, when
the chainsaw cuts the wood it can get
jammed which can lead to unnecessary
wear and damage to the machine!
13