Cisco 7513 Replacement Instructions Manual page 6

Removing Processor Modules
Step 6
Step 7
Figure 3
a
b
6 Cisco 7513 Card Cage and Backplane Assembly Replacement Instructions
Place your thumbs on the ejector levers on both ends of the processor module (see
Figure 3c) and simultaneously pull them both outward to release the processor module
from the backplane connector.
Grasp the processor module handle with one hand and place your other hand under the
carrier to support it. Pull the processor module straight out of the slot keeping it at a
90-degree orientation to the backplane. (See Figure 5 on page 8.)
Ejector Levers and Captive Installation Screws
Processor
module
carrier guide
Captive
installation
screw
STOP!
on contact
Bottom ejector lever
Processor module
slot
c