Starting The Test - General Sleep Zmachine Synergy Patient Manual

Starting the Test

Press the button for about 1-2 seconds until the lights turn on, then
release. Do not hold for too long or the system will shut off again.
Note: The Synergy will automatically check your sensors. A yellow
light indicates that the corresponding sensor is not yet connected or
needs further attention (green means good). Refer to the previous
instructions and correct any problems. If you are unsuccessful in
correcting a yellow indicator, simply continue with the test.
Go to bed when ready. Sleep in any position that is comfortable. It is
perfectly acceptable to lie on the wires or any other part of the system.
Hint: The lights will auto-dim to minimize interference with your sleep.
The system is still running while dim. A momentary button press will
briefly show the current status of all sensors and then auto-dim again.
Patient Guide 13