Step 5: Connect The Cannula - General Sleep Zmachine Synergy Patient Manual

Step 5: Connect the Cannula

Place cannula in nostrils, drape over ears, & remove some slack.
Adjust slider just a little to remove some slack. Do not tighten.
Apply small two pieces of tape as shown.
Gently twist cannula onto the fitting until it just stops (about ½ turn).
10
The slider should not be tight; a tight
cannula can be uncomfortable. The
tape will keep the cannula in the
correct position all night. Loosen the
slider now if needed.
Note: If you have sensitive skin, the
tape can leave temporary marks on
your face.
Do not overtighten
Tightening beyond snug
may damage the device.
Patient Guide