Step 2: Apply Sensor Pads - General Sleep Zmachine Synergy Patient Manual

Step 2: Apply Sensor Pads

Remove clear backing from sensor pad.
Apply a sensor pad to each of the three cleaned areas as shown.
Secure each sensor pad with finger by rubbing the outer edge only.
Avoid pressing the center as gel will spread onto the adhesive.
Hint: If you positioned a sensor pad incorrectly, simply repeat the
steps above using a new sensor pad (never reuse a sensor pad).
Wait 20 minutes before continuing onto Step 3.
This will let the sensor pads adhere properly to your skin.
Patient Guide 7