EQ Bypass Switch
This switch allows you to instantly set the EQ completely flat without loosing the current EQ settings.
CLIP LED
This LED indicates clipping in any section of the Pro Channel II.
You can isolate the source of the clipping to the INPUT section by reducing the Preamp output, if
the clipping LED remains lit. If the Clip LED goes out, the clipping is in the compressor or EQ section.
You can prevent clipping in the EQ section by reducing the Compressor output.
Master Output Control
The OUTPUT LEVEL control provides gain or attenuation to adjust for a variety of system operating
levels. This control affects the levels sent to the A/D converter and to the balanced analog OUTPUT
jacks.
FIGURE 4 – Signal Flow Block Diagram
9