Displaying And Maintaining Pos Interfaces - H3C S9500E Series Interface Configuration Manual

Step
16. Set the physical state change
suppression interval.
17. Restore the default settings.
18. Shut down the POS interface.
NOTE:
• The POS interface can operate in master clock mode only when the SRPU (or the main control board) is
installed with a clock daughter card.
IPv6CP of PPP cannot get the peer IPv6 address through auto negotiation. Therefore, when a POS
•
interface is used for IPv6 hardware forwarding, you need to configure static routes or routing protocols
on it.

Displaying and maintaining POS interfaces

Task
Display information about one or all
POS interfaces.
Display IP-related configurations and
statistics for one or all POS interfaces.
Display IPv6-related configurations and
statistics for one or all POS interfaces.
Clear the statistics on POS interfaces.
Command
link-delay msec milliseconds
default
shutdown
Command
display interface [ pos ] [ brief [ down ] ]
[ | { begin | exclude | include }
regular-expression ]
display interface [ pos
[ interface-number ] ] [ brief
[ description ] ] [ | { begin | exclude |
include } regular-expression ]
display ip interface pos
[ interface-number ] [ | { begin | exclude
| include } regular-expression ]
display ipv6 interface pos
[ interface-number | verbose ] [ | { begin
| exclude | include }
regular-expression ]
reset counters interface [ pos
[ interface-number ] ]
21
Remarks
Optional.
1000 milliseconds by default.
Optional.
Optional.
By default, a POS interface is up.
When you modify parameters on a
POS interface, execute the
shutdown command, and then the
undo shutdown command to make
your modifications take effect.
Remarks
Available in any view.
Available in any view.
Available in any view.
Available in user view.