Remote Control - Ferroli EXTERNO 11 User Manual

EXTERNO

29. REMOTE CONTROL

The appliance is supplied with a Remote Control and the corresponding connection cable (10m).
Positioning the Remote Control
Make sure that:
• The remote control cannot be accessed by children.
• It is NOT installed near sources of heat.
• It is NOT installed in areas which could become wet (by spraying).
Separate the fixing base by inserting a screwdriver into the two
side cracks and fix the Remote Control base to the wall in the
chosen area, using the screws supplied with the appliance.If
necessary, cut the cable supplied to the desired length and ap-
ply the connectors supplied in the package to ensure power is
supplied properly and safely.
Remote Control connection
Proceed as follows:
• Disconnect the appliance from the electricity supply by switching the external bipolar switch to OFF:
• Remove the casing as indicated in paragraph "Instructions for opening the casing and performing internl ispection".
• Insert the cable into the appliance via cable connection port L.
• Connect the cable to the P.C.B. - see electric diagram on following page.
L L
fig. 8 - L= RC connection port - Mod. 11 and 16 fig. 9 - L = RC connection port - Mod. 22 and 26
Remote control pairing with PCB
Under standby mode, keep pressing " " button for 2 secon-
ds and the HMI displays "11" code, the press ON/OFF button to
confirm and exit pairing. It'll confirm automatically after a short
while if ON/OFF button is still not pressed.To connect more re-
mote controllers, proceed the same steps, but the code will be
"12" and "13"in serie.The priority is allocated to controller "11"
as default.
54
EN
Cod. 3541T440 - Rev. 05 - 02/2020