User's Manual; Introduction; Control Panel; Turning The Heater On And Off - Ferroli PEGASO PRO 6 Instructions For Use, Installation And Maintenence

1 USER'S MANUAL

1.1 Introduction

The new PEGASO PRO is a high-performance, low-
emission heater for domestic hot water production,
powered by natural gas or LPG and equipped with a
compact, WATER-COOLED, battery-powered burner
with electronic ignition, designed for indoor and outdoor
installation (from -5 ° C to +60 ° C).

1.2 Control panel

3
fig. 1 - Control panel
3 Burner power adjustment

1.3 Turning the heater on and off

When the unit is working, the
temperature near the peephole
may be high. Avoid contact as
there may be risk of burns.
56
EN
4
4 Temperature adjustment
cod. 3542C020 - Rev. 00 - 09/2022
Preliminary checks and operations
1 Make sure the hot water taps are closed.
2 Open the gas supply cock to the heater, located at the
gas connection to the unit.
3 Check that the 1.5 V batteries are properly installed
with the correct polarity (+/-). To replace the batteries,
see (3.4 Replacing the batteries).
4 Also verify that the batteries are sufficiently charged
for heater operation.
1.3.1 Turning the unit on
Turn the knob to the required water heating level.
The unit will begin operating every time hot water is
drawn.
fig. 2 - Turning the unit on
1.3.2 Turning the unit off
The burner goes off automatically when hot water is no
longer demanded.
To use the unit again, no action is required.
To completely shut off the unit, place the knob in the ()
position .
fig. 3 - Turning the unit off
If the water heater will not be used for an extended pe-
riod of time, close the gas cock supplying the unit.
If the unit will be inactive for an
extended period of time during
the winter, all water should be
removed to avoid ice damage.
PEGASO PRO