Table of Contents
Advertisement
REASSEMBL Y PROCEDURE
3. UW-tube
3-1.
Depression prism unit (Refer to Fig. 3)
1) Applying a trifle of
adhesive No.
616
to the threaded part
ofmount
@,
screw it into bottom
plate
@
(Fig. 25).
2)
Attach sliding plate
@
and dovetail
groove
@
(the
one that has not
been disassembled)
to
@,
transitorily.
3) Perform the posi-
tioning of
@
in
respective to
@
as below:
lnsert the male dove·
tail of prism holder
@
into the fiducial
one (has not been disassembled) of
@,
and move
@
parallel in the direction of
the arrow, as shown in Fig. 26. ln this
case, keep thê slack within about O.Olmm.
4) Apply oil G7920 to the sliding surface
for dovetail fitting. Check for smooth
sliding, and for slow dropping of
@
by
itself, when holding
@
with the hand.
5) Apply adhesive No. 350 into
@xa.
- 30-
R-4106.A
3. UW·tube
Fig. 25
"~
' C I
,~.
'..::::'./, 8
1
17
1
Fig. 26
Hide quick links:
Advertisement
Table of Contents
