Lubricating The Bearings; Lubricating The Pto Shaft - Farmi CH27 ACR Operation, Maintenance And Spare Parts Manual

LUBRICATING THE BEARINGS

1. The bearings are lubricated at the factory,
and a similar lubricant should be used
for subsequent lubrication (Shell Alvania
Grease R 3. or Kendall L427). An excessive
amount of grease causes overheating and
impairs lubrication.
2. Lubricate the bearings after 50 working
hours. The correct amount of lubricant is
5-6 presses/lubrication/bearing.

LUBRICATING THE PTO SHAFT

1. Lubricate the PTO shaft prior to operation
and regularly, as shown in picture.
2. Lubricate the inner surface of the PTO shaft,
accessed via the outer profile tube.
3. Lubricate the shield tubes in wintertime to
prevent them from freezing and sticking.
Swing the joints sideways for lubrication.
8h
Lubricate the shield tubes in
wintertime to prevent them
from freezing and sticking.
CH27 ACR/ACC PROFI
8h
20h
Lubricate the outer profile
tube's inner surface.
h = working hours
62